Nissan Sentra/Pulsar/NX 1982-1996 Repair Guide

Outside Mirrors

Print

REMOVAL & INSTALLATION



See Figures 1, 2, 3 and 4



Click image to see an enlarged view

Fig. Fig. 1: There are 2 basic types of door finisher panels. Type A is found on vehicles with a manual remote control mirror; type B is found on vehicles with power mirrors or no remote control



Click image to see an enlarged view

Fig. Fig. 2: There are typically 3 fasteners securing the mirror to the door



Click image to see an enlarged view

Fig. Fig. 3: Upon installation, apply sealer to the rear surface of the finisher panel



Click image to see an enlarged view

Fig. Fig. 4: Power mirror installation-1982-90 vehicles

Manual
  1. Remove control knob handle.
  2.  
  3. Remove door corner finisher panel.
  4.  
  5. Remove mirror body attaching screws, and then remove mirror body.
  6.  
  7. Installation is in the reverse order of removal.
  8.  

Apply sealer to the rear surface of the door corner finisher panel during installation to prevent water leakage.

Power
  1. Remove door corner finisher panel.
  2.  
  3. Remove mirror body attaching screws, and then remove mirror body.
  4.  
  5. Disconnect the electrical connection.
  6.  

It may be necessary to remove the door trim panel to gain access to the electrical connection.

  1. Installation is in the reverse order of removal.
  2.  

 
label.common.footer.alt.autozoneLogo