Nissan Sentra/Pulsar/NX 1982-1996 Repair Guide

Rear Wiper Motor

Print

REMOVAL & INSTALLATION



To perform this procedure, you will need a soft material (such as RTV sealer) used to seal the plastic watershields used in vehicle doors and tailgates.

  1. Disconnect the negative battery cable. Bend the wiper arm to raise the wiper blade off the rear window glass. Then, remove the attaching bolt or nut and washers and work the wiper arm off the motor shaft.
  2.  
  3. Remove the attaching screws and remove the tailgate inner finish panel. Carefully peel the plastic water shield off the sealer.
  4.  
  5. Disconnect the electrical connector at the motor. Remove the motor mounting bolts and remove the motor.
  6.  
  7. Install the motor in reverse of the removal procedure. Before installing the water shield, run a fresh ring of RTV sealer around the outer edge.
  8.  

 
label.common.footer.alt.autozoneLogo