Nissan Stanza/200SX/240SX 1982-1992 Repair Guide

Brake Light Switch

Print

REMOVAL & INSTALLATION



  1. Disconnect the negative battery cable.
  2.  
  3. Disconnect the wiring connector at the switch.
  4.  
  5. Remove the switch lock nut.
  6.  
  7. Remove the switch.
  8.  
  9. Install the switch and adjust it so the brake lights are not on unless the brake pedal is depressed.
  10.  

ADJUSTMENT



Adjust the clearance between the brake pedal and the stop lamp switch or the ASCD switch, by loosening the lock-nut and adjusting the switch. The clearance should be approximately 1.0mm for Stanza (1982-84) or 0.30-1.00mm for Stanza and all other models. Use this service procedure as a guide if necessary.

The stop light switch is adjusted so that the switch is not activated when the brake pedal is relaxed.

 
label.common.footer.alt.autozoneLogo