Nissan Stanza/200SX/240SX 1982-1992 Repair Guide

ASCD Cable

Print

REMOVAL & INSTALLATION



  1. Disconnect the cable from the actuator assembly--loosen the lock nut at actuator assembly and remove the rubber boots.
  2.  
  3. Loosen the lock-nut at intake manifold bracket. Remove the cable.
  4.  
  5. Installation is the reverse of the removal procedures. Adjust the cable as required. When removing or installing wire end use care not damage. Check system for proper operation.
  6.  

ADJUSTMENT



1982-83 200SX

Without depressing the accelerator pedal, adjust the adjusting nut until cable free play is within 0.08-0.012 in. (2-3mm) at throttle lever. Tighten the lock nut.

1984-88 200SX240SXStanza (Vacuum Type)

1990-92 Stanza

Without depressing the accelerator pedal, adjust the adjusting nuts until there is no free play or portion A of throttle lever comes in contact with assembly. Then return adjustment (back off) nuts 1 / 2 -1 turn back to gain free play. Securely tighten lock nut to hold adjusting nut in place.

Stanza (Positive Pressure Type)

On the this type system, the actuator cable is operated by compressed air produced in the compressor built into the actuator assembly.

Without depressing the accelerator pedal, adjust the adjusting nuts until there is no free play--tighten lock nut.

 
label.common.footer.alt.autozoneLogo