Nissan Stanza/200SX/240SX 1982-1992 Repair Guide

Signal And Marker Lights

Print

REMOVAL & INSTALLATION



Front Turn Signal And Parking Lights

See Figures 1, 2, 3 and 4



Click image to see an enlarged view

Fig. Fig. 1: Light bulb removal and installation - 240SX



Click image to see an enlarged view

Fig. Fig. 2: Light bulb removal and installation - 240SX



Click image to see an enlarged view

Fig. Fig. 3: Light bulb removal and installation - 240SX



Click image to see an enlarged view

Fig. Fig. 4: Light bulb removal and installation - 240SX

  1. Refer to the illustrations. Remove turn signal/parking light lens with retaining screws.
  2.  
  3. Slightly depress the bulb and turn it counterclockwise to release it.
  4.  
  5. To install the bulb carefully push down and turn bulb clockwise at the same time.
  6.  
  7. Install the turn signal/parking light lens with retaining screws.
  8.  

Side Marker Lights

See Figures 5, 6, 7 and 8



Click image to see an enlarged view

Fig. Fig. 5: Light bulb removal and installation - Stanza



Click image to see an enlarged view

Fig. Fig. 6: Light bulb removal and installation - Stanza



Click image to see an enlarged view

Fig. Fig. 7: Light bulb removal and installation - Stanza



Click image to see an enlarged view

Fig. Fig. 8: Light bulb removal and installation - Stanza

  1. Refer to the illustrations. Remove side marker light lens with retaining screws.
  2.  
  3. Turn the bulb socket counterclockwise to release it from lens.
  4.  
  5. Pull bulb straight out.
  6.  
  7. To install bulb carefully push straight in.
  8.  
  9. Turn the bulb socket clockwise to install it in lens.
  10.  
  11. Install side marker light lens with retaining screws.
  12.  

Rear Turn Signal, Brake And Parking Lights

See Figures 9, 10 and 11



Click image to see an enlarged view

Fig. Fig. 9: Light bulb removal and installation - 200SX



Click image to see an enlarged view

Fig. Fig. 10: Light bulb removal and installation - 200SX



Click image to see an enlarged view

Fig. Fig. 11: Light bulb removal and installation - 200SX

  1. Refer to the illustrations. Remove rear trim panel in rear of vehicle if necessary to gain access to the bulb socket.
  2.  
  3. Slightly depress the bulb and turn it counterclockwise to release it.
  4.  
  5. To install the bulb carefully push down and turn bulb clockwise at the same time.
  6.  
  7. Install trim panel if necessary.
  8.  

High-Mount Brake Stop Light/Dome Light Cargo Light/License Plate Light

See Figure 12



Click image to see an enlarged view

Fig. Fig. 12: Light Bulb Chart

 
label.common.footer.alt.autozoneLogo