Nissan Titan 2004-06

Pinion Seal

Print

Removal & Installation



  1. Remove the rear drive shaft.
  2.  
  3. Remove brake calipers and rotors.
  4.  
  5. Measure and record the total preload.
  6.  
  7. Matchmark the drive pinion to position -B- on the companion flange.
  8.  
  9. Remove the drive pinion nut using suitable tool.
  10.  
  11. Remove the companion flange using suitable tool.
  12.  
  13. Remove the rear pinion seal using special tool J-34286.
  14.  


    Click image to see an enlarged view

    Fig. Companion flange marking



    Click image to see an enlarged view

    Fig. Loosening the flange nut



    Click image to see an enlarged view

    Fig. Removing the companion flange



    Click image to see an enlarged view

    Fig. Removing the pinion seal


To install:

  1. Press the rear pinion seal into the carrier using suitable tool.
  2.  
  3. Align the matchmark on the companion flange to the drive pinion and install the companion flange.
  4.  
  5. Lubricate the drive pinion threads and seating surfaces of the drive pinion nut with grease.
  6.  
  7. Using a new drive pinion nut, tighten to 124-274 ft. lbs. (167-372 Nm).
  8.  


NOTE
Final torque is determined when adjusting total preload using special tool J-25765-A.

  1. Install brake calipers and rotors.
  2.  
  3. Install rear drive shaft.
  4.  

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Remove the rear drive shaft.
  4.  
  5. Remove brake calipers and rotors.
  6.  
  7. Measure and record the total preload.
  8.  
  9. Matchmark the drive pinion to position -B- on the companion flange.
  10.  
  11. Remove the drive pinion nut using suitable tool.
  12.  
  13. Remove the companion flange using suitable tool.
  14.  
  15. Remove the rear pinion seal using special tool J-34286.

    Click image to see an enlarged view

    Fig. Companion flange marking



    Click image to see an enlarged view

    Fig. Loosening the flange nut



    Click image to see an enlarged view

    Fig. Removing the companion flange



    Click image to see an enlarged view

    Fig. Removing the pinion seal

  16.  

To install:

  1. Press the rear pinion seal into the carrier using suitable tool.
  2.  
  3. Align the matchmark on the companion flange to the drive pinion and install the companion flange.
  4.  
  5. Lubricate the drive pinion threads and seating surfaces of the drive pinion nut with grease.
  6.  
  7. Using a new drive pinion nut, tighten to 124-274 ft. lbs. (167-372 Nm).
    NOTE
    Final torque is determined when adjusting total preload using special tool J-25765-A.

  8.  
  9. Install brake calipers and rotors.
  10.  
  11. Install rear drive shaft.
  12.  

 
label.common.footer.alt.autozoneLogo