Nissan Z - ZX 1970-1988 Repair Guide

Gauges

Print

REMOVAL & INSTALLATION



240 Z Models
  1. Remove the instrument panel finish panel.
  2.  
  3. Loosen the hex-head screws on the back of the instrument to be removed.
  4.  
  5. Pull the gauge to the rear, unfasten the electrical connector and remove it.
  6.  
  7. To install, reverse the removal procedures.
  8.  

260 Z and 280 Z Models

See Figures 1 and 2

  1. Remove the retaining screws for the instrument finish panel (located under the three small gauges) and pull the panel out slightly. Unfasten the electrical connectors and remove the finish panel.
  2.  
  3. Remove the three-way duct-to-instrument panel screws and the three-way duct-to-bracket screws.
  4.  
  5. Disconnect the duct hoses and remove the duct.
  6.  
  7. Remove the screw(s) retaining the gauge(s) to be removed from the instrument panel.
  8.  
  9. Pull the gauge to the rear, unfasten the connector and remove the gauge.
  10.  
  11. To install, reverse the removal procedures.
  12.  



Click image to see an enlarged view

Fig. Fig. 1: Remove the retaining screws securing the duct below the gauges



Click image to see an enlarged view

Fig. Fig. 2: Remove the gauge retaining screws

 
label.common.footer.alt.autozoneLogo