Nissan Z - ZX 1970-1988 Repair Guide

Rear Window Wiper Switch

Print

REMOVAL & INSTALLATION



280 ZX Models

The rear window wiper switch is located on the left side of the instrument panel.

  1. Pull the rear window wiper switch knob from the switch.
  2.  
  3. Using a spanner wrench tool, remove the retaining nut and the washer from the switch.
  4.  
  5. Remove the switch from the back of the instrument panel and unfasten the electrical connector.
  6.  
  7. To install, reverse the removal procedures.
  8.  

300 ZX Models

See Figure 1

The rear window wiper switch is located on the right side of the instrument panel.

  1. Refer to the Instrument Cluster removal and installation procedures in this section, and remove the instrument cluster.
  2.  
  3. Remove the nut retaining the instrument combination switch to the dash.
  4.  



Click image to see an enlarged view

Fig. Fig. 1: Removing the rear wiper switch attachment hooks-1987 300 ZX shown

The instrument combination switches are secured by hooks and basements.

  1. Unfasten the electrical connectors from the rear of the switch, then remove it.
  2.  
  3. To install, reverse the removal procedures.
  4.  

 
label.common.footer.alt.autozoneLogo