Odyssey 2007-2008

Moonroof

Print

Power Moonroof



Diagnosis & Testing
Motor

Specific to:

Honda Odyssey 2007-2008

  1. Remove the headliner to access the moonroof motor. For additional information, refer to the following section, -Power Moonroof, Removal and Installation.-
  2.  
  3. Disconnect the wiring harness from the moonroof motor.
  4.  
  5. Check the motor by connecting power and ground according to the table.
  6.  
  7. If the motor does not run, replace it.

    Click image to see an enlarged view

    Fig. Check the motor by connecting power and ground according to the table-Odyssey moonroof motor

  8.  

Switch

Specific to:

Honda Odyssey 2007-2008

  1. Check for continuity between the terminals in each switch position according to the table.
  2.  
  3. If the continuity is not as specified, replace the illumination bulbs or the switch.

    Click image to see an enlarged view

    Fig. Check for continuity between the terminals in each switch position-Odyssey moonroof switch

  4.  

Removal & Installation
Motor

Specific to:

Honda Odyssey 2007-2008

  1. Disconnect the battery cables. Wait at least 3 minutes before beginning work.
  2.  
  3. Remove the following interior trim pieces:

    A-pillar trim, both sides
     
    Front seat belt upper anchor, both sides
     
    B-pillar lower trim, both sides
     
    B-pillar upper trim, both sides
     
    C-pillar trim, both sides
     
    D-pillar trim, both sides
     
    Sun visors, both sides
     
    Grab handles, six places
     
    Rear individual map lights
     
    Center second row seat belt cover
     
    Center third row seat belt cover
     
    RES display cover, if equipped with rear entertainment system
     
    Rear A/C control panel
     

  4.  
  5. Remove the overhead console as follows:
    1. Remove the light covers.
    2.  
    3. Remove the mounting bolts.
    4.  
    5. Pull out the overhead console and front individual map light.
    6.  
    7. Disconnect the wiring harnesses.
    8.  

  6.  
  7. Remove the rear ceiling vents, if equipped, as follows:
    1. Remove the light cover.
    2.  
    3. Slide the vent to the closed position to expose the screw.
    4.  
    5. Remove the screw and the nut (rear left side only).
    6.  
    7. Pull out the rear ceiling vent to release the clip, and disconnect the map light connector.
    8.  

  8.  
  9. Remove the headliner as follows:
    1. Remove any remaining wiring harness or mounting bolts in the center area of the headliner.
    2.  
    3. Remove the front door opening trim, sliding door opening trim, and the tailgate weatherstrip from each roof portion.
    4.  
    5. With the help of an assistant, detach the rear clips by pulling the rear portion of the headliner down.
    6.  
    7. Release the Velcro® fasteners and detach the front clips by lowering the headliner.
    8.  
    9. Lower the headliner, and remove it through the tailgate opening.
      CAUTION
      Wear gloves to protect your hands.



      Click image to see an enlarged view

      Fig. Removing the headliner

    10.  

  10.  
  11. Disconnect the wiring harness and remove the moonroof motor mounting bolts.
  12.  
  13. Remove the moonroof motor.
  14.  

To install:

  1. Installation is the reverse order of removal.
  2.  

Switch

Specific to:

Honda Odyssey 2007-2008

  1. Open the front door, and remove the dashboard side cover.
  2.  
  3. Push the bottom hook back by hand, and pull out the bottom of the driver's dashboard outer panel.

    Click image to see an enlarged view

    Fig. Push the bottom hook back by hand, and pull out the bottom to remove the driver's dashboard outer panel

  4.  
  5. Carefully push out the moonroof switch from behind the driver's dashboard outer panel, then disconnect the wiring harness from the switch.
  6.  

To install:

  1. Installation is the reverse order of removal.
  2.  

 
label.common.footer.alt.autozoneLogo