Odyssey 2007-2008

Locks & Lock Systems

Print

Power Door Locks



Diagnosis & Testing
  1. Remove the door panel. For additional information, refer to the following section, -Power Door Locks, Door Lock Motor.-
  2.  
  3. Disconnect the door lock motor wiring harness.
  4.  
  5. Check actuator operation by connecting power and ground according to the table.
    WARNING
    To prevent damage to the actuator, apply battery voltage only momentarily.

  6.  
  7. If the actuator does not operate as specified, replace it.

    Click image to see an enlarged view

    Fig. Check door lock motor operation by connecting power and ground according to the table

  8.  

Removal & Installation
Door Lock Motor

Specific to:

Honda Odyssey 2007-2008


NOTE
This procedure covers the replacement of the door lock switch (control panel) and requires the use of KTC trim tool set SOJATP2014 and Trim pad remover, Snap-on® A177A, or equivalent, commercially available trim removal tools.


NOTE
Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.

  1. Lower the window glass fully.
  2.  
  3. Using the appropriate trim tool, pry out on the rear portion of the cover to release the hooks, then remove the cover and the screws securing the inner handle.

    Click image to see an enlarged view

    Fig. Using the appropriate trim tool, pry out on the rear portion of the cover (A) to release the hooks (B, C), then remove the cover and the screws securing the inner handle (D)

  4.  
  5. Remove the power window switch panel, as follows:
    1. Using the appropriate trim tool pry up on the rear edge of the switch panel tape to release the rear clip.
    2.  
    3. Pull out along the edge of the panel to release the hooks and front clip.
    4.  
    5. Disconnect the power mirror switch connector (driver's) and the power window switch connector.

      Click image to see an enlarged view

      Fig. Removing the power window switch panel (A)

    6.  

  6.  
  7. Remove the door panel with as little bending as possible to avoid creasing or breaking it, as follows:
    1. Remove the screws.
    2.  
    3. Use a commercially available trim pad remover to detach the clips.
    4.  
    5. Starting at the rear, pull the door panel upward, then release the lock knob.
      WARNING
      To prevent damaging the components inside the door, don-t use excessive force when raising the panel.



      Click image to see an enlarged view

      Fig. Door panel (A) removal

    6.  

  8.  
  9. Disconnect the inner handle cable from the inner handle.
  10.  
  11. Disconnect the courtesy light bulb connector and the driving position memory switch connector, then remove the door panel. Take care not to bend the cable.
  12.  
  13. If necessary, remove the screws securing the inner handle, then remove the handle from the door panel.
  14.  
  15. Disconnect the door lock wiring harness and remove the door lock motor.
  16.  

To install:

  1. Install the door lock switch and secure with the retainers.
  2.  
  3. Install the door panel in the reverse order of removal, and note these items:
    1. Replace any damaged clips.
    2.  
    3. Make sure the connectors are plugged in properly, and that the cable and the bulb socket are connected properly.
    4.  
    5. Make sure the window and power door lock operate properly.
    6.  

  4.  

Door Lock Switch

Specific to:

Honda Odyssey 2007-2008

The door lock switch is located in the same control panel as the power window switch. For additional information, refer to the following section, -Power Windows, Window Switch.-

 
label.common.footer.alt.autozoneLogo