Odyssey 2007-2008

Coil Springs

Print

Removal & Installation



  1. Raise the rear of the vehicle, and support it with safety stands in the proper locations.
  2.  
  3. Remove the rear wheel.
  4.  
  5. Position a floor jack at the connecting point of the lower arm B and the knuckle.
  6.  
  7. Remove the flange bolt (A) that connects the lower arm B and the knuckle.

    Click image to see an enlarged view

    Fig. Remove the flange bolt (A) that connects the lower arm B and the knuckle

  8.  
  9. Lower the floor jack gradually.
  10.  
  11. Remove the spring, upper spring seat, and lower spring seat.
  12.  
  13. Remove the flange bolt that connects to the body, and remove the bump stop.
  14.  

To install:

  1. Install the bump stop (A), and tighten the flange bolt (C) to the specified torque value.
  2.  
  3. Install the upper spring seat (D) and spring (E). Align the bottom of the spring and the lower spring seat (F) with lower arm B as shown.

    Click image to see an enlarged view

    Fig. Install the bump stop (A), and tighten the flange bolt (C) to the specified torque value. Install the upper spring seat (D) and spring (E). Align the bottom of the spring and the lower spring seat (F) with lower arm B as shown

  4.  
  5. Position a floor jack at the connecting point of the lower arm B and the knuckle.
  6.  
  7. Slowly raise the jack until you can align the bolt hole with the holes in the lower arm B and the knuckle and install the flange bolt (A).
  8.  
  9. Raise the rear suspension with a floor jack until the vehicle just lifts off the safety stands.
  10.  
  11. Tighten the flange bolt.
  12.  
  13. Install the rear wheel.
  14.  
  15. Check the rear wheel alignment, and adjust it if necessary.
  16.  

 
label.common.footer.alt.autozoneLogo