Odyssey 2007-2008

Rear Window Wiper/Washer Systems

Print

Removal & Installation



Wiper Motor

Specific to:

Honda Odyssey 2007-2008

  1. Open the tailgate, and remove the tailgate trim panel as follows:
    1. Detach the hooks and the tabs from the left tailgate side trim and the right tailgate side trim.
    2.  
    3. Pull the tailgate upper trim panel back by hand to detach the clips, then remove it.
    4.  
    5. Pull out the top of the side trim to detach the clips.
    6.  
    7. Detach the tabs and the hooks from the tailgate lower trim panel.
    8.  
    9. Release the hooks, then remove the tailgate grip cover and the self-tapping ET screws.
    10.  
    11. Gently pry on the rear power tailgate close switch to detach the clips, then disconnect the switch connector, if equipped with power tailgate.
    12.  
    13. Detach the tailgate lower trim panel by pulling it out to disengage the clips and then remove it.
    14.  

  2.  
  3. Remove the mounting nut, the wiper arm and the special nut.

    Click image to see an enlarged view

    Fig. Remove the mounting nut (A), rear wiper arm (B) and special nut (C)

  4.  
  5. Disconnect the wiring harness and remove the mounting bolts for the rear wiper motor.
  6.  

To install:

  1. Installation is the reverse order of removal.
  2.  

Wiper Washer

Specific to:

Honda Odyssey 2007-2008

The wiper washer unit uses a single motor. For additional information, refer to the following section, -Window Wiper and Washers, Front Wiper Washer.-

 
label.common.footer.alt.autozoneLogo