PT Cruiser, 2001 - 2005

Knock Sensor

Print

Description & Operation



The knock sensor threads into the cylinder block. The knock sensor is designed to detect engine vibration that is caused by detonation. When the knock sensor detects a knock in one of the cylinders, it sends an input signal to the PCM. In response, the PCM retards ignition timing for all cylinders by a scheduled amount.

Knock sensors contain a piezoelectric material, which constantly vibrates and sends an input voltage (signal) to the PCM while the engine operates. As the intensity of the crystals vibration increases, the knock sensor output voltage also increases.

The voltage signal produced by the knock sensor increases with the amplitude of vibration. The PCM receives as an input the knock sensor voltage signal. If the signal rises above a predetermined level, the PCM will store that value in memory and retard ignition timing to reduce engine knock. If the knock sensor voltage exceeds a preset value, the PCM retards ignition timing for all cylinders. It is not a selective cylinder retard.

The PCM ignores knock sensor input during engine idle conditions. Once the engine speed exceeds a specified value, knock retard is allowed.

Knock retard uses its own short term and long-term memory program. Long-term memory stores previous detonation information in its battery-backed RAM. The maximum authority that long term memory has over timing retard can be calibrated. Short-term memory is allowed to retard timing up to a preset amount under all operating conditions (as long as rpm is above the minimum rpm) except WOT. The PCM, using short-term memory, can respond quickly to retard timing when engine knock is detected. Short-term memory is lost any time the ignition key is turned off.


NOTE
Over or under tightening affects knock sensor performance, possibly causing improper spark control.

Removal & Installation



  1. Disconnect electrical connector from knock sensor.
  2.  
  3. Use a crowfoot socket to remove the knock sensors.
  4.  

To install:

  1. Install knock sensor. Tighten knock sensor to 10 Nm (7 ft. lbs.) torque.
  2.  
  3. Attach electrical connector to knock sensor.

    Click image to see an enlarged view

    Fig.

  4.  

 
label.common.footer.alt.autozoneLogo