PT Cruiser, 2001 - 2005

Speed Control Switch Connectors

Print

Removal & Installation



The speed control switches is mounted in the steering wheel and wired through the clock spring device under the airbag module.


CAUTION
If removal & installation of airbag module is necessary, follow proper instructions and precautions.

  1. Remove the air cleaner lid; disconnect the inlet air temperature sensor and makeup air hose.
  2.  
  3. Remove the negative battery cable.
  4.  
  5. Turn off ignition.
  6.  
  7. Remove air bag.
  8.  
  9. Remove the top mounting screw.
  10.  
  11. Rotate steering wheel so that the switch is in the 6 oclock position. Remove 2 screws from the backside of the speed control switch.
  12.  
  13. Disconnect the electrical connector.
  14.  
  15. Remove switch.
  16.  

To install:

The speed control switch is mounted in the steering wheel and wired through the clock spring device under the airbag module.

  1. Connect the electrical connector.
  2.  
  3. Install switch and tighten the screws to 1.6 Nm (15 inch lbs.). Make sure rubber seal is in place around switch.
  4.  
  5. Install airbag.
  6.  
  7. Install the negative battery cable.
  8.  
  9. Install the air cleaner lid; connect the inlet air temperature sensor and makeup air hose.
  10.  

 
label.common.footer.alt.autozoneLogo