PT Cruiser 2006-2007

Removal & Installation

Print

Non-Turbo Models



  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Disconnect the negative battery cable.
  4.  
  5. Partially drain cooling system below level of Engine Coolant Temperature (ECT) sensor.
  6.  
  7. Disconnect the ECT sensor electrical connector.
  8.  
  9. Remove ECT sensor.

    Click image to see an enlarged view

    Fig. Location of the Engine Coolant Temperature (ECT) sensor-Non-Turbo models

  10.  

To install:

  1. Install ECT sensor. Torque sensor to 168 inch lbs. (19 Nm).
  2.  
  3. Reconnect ECT sensor electrical connector.
  4.  
  5. Fill cooling system.
  6.  
  7. Connect negative battery cable.
  8.  

Turbo Models



  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Disconnect the negative battery cable.
  4.  
  5. Partially drain cooling system below level of ECT Sensor.
  6.  
  7. Remove upper torque strut.
  8.  
  9. Disconnect ECT sensor electrical connector.
  10.  
  11. Remove ECT sensor.

    Click image to see an enlarged view

    Fig. Location of the Engine Coolant Temperature (ECT) sensor-turbo models

  12.  

To install:

  1. Install ECT sensor. Torque sensor to 168 inch lbs. (19 Nm).
  2.  
  3. Reconnect ECT sensor electrical connector.
  4.  
  5. Install upper torque strut.
  6.  
  7. Fill cooling system.
  8.  
  9. Connect negative battery cable.
  10.  

 
label.common.footer.alt.autozoneLogo