PT Cruiser 2006-2007

Fuel Pressure Regulator

Print

Removal & Installation



  1. The fuel pressure regulator is part of the fuel pump module. Remove the fuel pump module from the fuel tank to access the fuel pressure regulator. Refer to the Fuel Pump Module removal in this section.
    CAUTION
    Fuel system pressure must be released before servicing any fuel system component. Failure to do so may result in personal injury or death.

  2.  
  3. Perform the fuel system pressure release procedure.
  4.  
  5. Spread tangs on pressure regulator retainer.
  6.  
  7. Pry fuel pressure regulator out of housing.
  8.  
  9. Ensure that the O-ring was removed with regulator.

    Click image to see an enlarged view

    Fig. View of the retaining clip for the fuel pressure regulator

  10.  

To install:

  1. The fuel pressure regulator is part of the fuel pump module. Remove the fuel pump module from the fuel tank to access the fuel pressure regulator. Refer to the Fuel Pump Module removal in this section.
  2.  
  3. Lightly lubricate the O-ring with clean engine oil and place them into opening in pump module.
  4.  
  5. Push regulator into opening in pump module.
  6.  
  7. Push regulator retainer over tabs on housing.
  8.  
  9. Install the Fuel Pump Module.
  10.  

 
label.common.footer.alt.autozoneLogo