PT Cruiser 2006-2007

Fuel Pump

Print

Removal & Installation



The fuel pump is integral with the pump module, which also contains the fuel reservoir, level sensor, inlet strainer and fuel pressure regulator. The inlet strainer, fuel pressure regulator and level sensor are the only serviceable items. If the fuel pump requires service, replace the entire fuel pump module.

Click image to see an enlarged view

Fig. Exploded view of the fuel pump module

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Properly relieve the fuel system pressure.
  4.  
  5. Remove or disconnect the following:

    The negative battery cable
     
    The air cleaner lid
     
    The Inlet Air Temperature (IAT) sensor and make up air hose
     
    The fuel tank
     
    The fuel pump module and seal from the tank
     
    The locknut to release the fuel pump module, using a Ring Spanner Tool No. 6856
     
    The fuel filter from the fuel pump module
     
    The fuel pump and seal from the fuel tank

    Click image to see an enlarged view

    Fig. Exploded view of the fuel pump module

     

  6.  

To install:

  1. Install or connect the following:

    The fuel filter to the fuel pump module
     
    The fuel filter lines to the fuel pump module
     
    The fuel pump module in the tank
     
    The locknut while holding the fuel pump in position. Using Tool 6856, torque the nut to 56 ft. lbs. (75 Nm).
     
    The fuel tank
     
    The IAT sensor and make-up hose
     
    The air cleaner lid
     
    The negative battery cable
     

  2.  
  3. Fill the fuel tank.
  4.  
  5. Start the vehicle and check for leaks, repair if necessary.
  6.  

 
label.common.footer.alt.autozoneLogo