Pacifica 2006-2008

Verification Test

Print

The following procedure requires using a scan tool to verify proper Supplemental Restraint System (SRS) operation following the service or replacement of any SRS component.

  1. Be sure that the negative battery cable is disconnected and isolated.
  2.  
  3. Connect the scan tool to the Data Link Connector (DLC).
  4.  
  5. Exit the vehicle but maintain contact with the scan tool.
  6.  
  7. Turn the ignition switch to the ON position.
  8.  
  9. Be sure no one is in the vehicle.
  10.  
  11. Connect the negative battery cable.
  12.  
  13. Using the scan tool, read and record any ACTIVE(current) Diagnostic Trouble Code (DTC) data.
  14.  
  15. Use the scan tool to read and record any STORED (historical) Diagnostic Trouble Code (DTC) data.
  16.  
  17. If any DTC-s are found, refer to the appropriate diagnostic data.
  18.  
  19. Use the scan tool to erase any stored DTC data.
  20.  
  21. Turn the ignition switch to the OFF position. Wait 15 seconds, and then turn the ignition switch to the ON position.
  22.  
  23. If the airbag warning lamp either fails to light, or goes ON and stays ON, there is a system malfunction.
  24.  
  25. If a fault is detected, it must be corrected.
  26.  

 
label.common.footer.alt.autozoneLogo