Pacifica 2006-2008

Window Systems

Print

Power Window System



Diagnosis & Testing
Switch

NOTE
Any diagnosis of the power window system should begin with the use of the scan tool.


NOTE
For complete circuit diagrams, refer to the appropriate wiring information.


NOTE
The diagnosis found here applies only to the rear door power window switches. If the problem being diagnosed is an inoperative power window switch illumination lamp, but the power window switch operates as designed, replace the faulty rear door power window switch (verify the power lockout switch is not actuated).

  1. Disconnect and isolate the battery negative cable.
  2.  
  3. Remove the power window switch from the rear door trim panel.
  4.  
  5. Check the rear door power window switch continuity.
  6.  

Removal & Installation
Switch
  1. Disconnect and isolate the battery negative cable.
  2.  
  3. Remove the rear door trim panel.
  4.  
  5. Remove the mounting fasteners and power window switch.
  6.  

To install:

  1. Installation is the reverse of the removal procedure.
  2.  

Window Motor & Regulator

NOTE
Secure window in the UP position before removing motor.

  1. Disconnect and isolate the battery negative cable.
  2.  
  3. Remove the door trim panel.
  4.  
  5. Remove the door speaker.
  6.  
  7. Remove the watershield.
  8.  
  9. Disconnect the electrical harness wire connector from the motor.
  10.  
  11. For rear window, loosen window the regulator mounting fasteners (do not remove).
  12.  
  13. Remove mounting fasteners and motor.
  14.  

To install:

  1. Install the motor and mounting fasteners to regulator.
  2.  
  3. For rear window, install the window regulator.
  4.  
  5. Connect the electrical harness connector.
  6.  
  7. Install the door speaker
  8.  
  9. Install the door trim panel.
  10.  
  11. Connect the battery negative cable.
  12.  

 
label.common.footer.alt.autozoneLogo