Pacifica 2006-2008

Windshield Wiper Systems

Print

Removal & Installation



Wiper Module
  1. Disconnect and isolate the battery negative cable.
  2.  
  3. Remove the cowl plenum grille.
  4.  
  5. Disconnect the wiper motor electrical connector.
  6.  
  7. Remove the four retaining bolts to the wiper module.
  8.  
  9. Remove wiper module from vehicle.
  10.  

To install:

  1. Place the wiper module into position in vehicle.
  2.  
  3. Install the four retaining bolts to the wiper module.
  4.  
  5. Connect the wiper motor electrical connector.
  6.  
  7. Install the cowl plenum grille.
  8.  
  9. Connect the battery negative cable.

    Click image to see an enlarged view

    Fig. View of front wiper module

  10.  

Wiper Motor
  1. Disconnect and isolate the battery negative cable.
  2.  
  3. Remove the wiper module.
  4.  
  5. With the wiper module on a bench, pry apart the socket and ball joint at the end of the bell crank .
  6.  
  7. Remove the three front wiper motor mounting bolts and remove motor from module/linkage.

    Click image to see an enlarged view

    Fig. View of front wiper motor, mounting bolts, bell crank, and bell crank to output shaft retaining nut mounted on module/linkage

  8.  

To install:

  1. Position the wiper motor into wiper module and install the three front wiper motor mounting bolts.
  2.  
  3. Press the socket and ball joint together on end of bell crank.
  4.  
  5. Install the wiper module.
  6.  
  7. Connect the battery negative cable.
  8.  

Wiper Arms



Removal & Installation
  1. Using a trim stick or equivalent, gently pry the arm retaining nut cap off.
  2.  
  3. Remove the nut holding the wiper arm to the wiper pivot.
  4.  
  5. Using a suitable two jaw puller, separate the wiper arm from the wiper pivot.

    Click image to see an enlarged view

    Fig. View of front wiper arm assembly

  6.  

To install:

  1. Position the wiper arm onto the wiper arm pivot in approximate position with the tips of the wiper blades on the tick marks at the bottom of the windshield.
  2.  
  3. Install the nut holding the wiper arm to the wiper pivot. Tighten the nut to 160 inch lbs. (18 Nm).
  4.  
  5. Install the retaining nut cover by firmly pressing down on cover over wiper pivot.
  6.  
  7. Check wiper arm adjustment.
  8.  

 
label.common.footer.alt.autozoneLogo