ParkAvenue 1997-1999

Lower Control Arms


Removal & Installation

  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  3. Remove or disconnect the following:

    Rear suspension support assembly
    Electronic Ride Control height sensor
    Tie rod
    Stabilizer link assembly from the control arm
    Antilock Brake System (ABS) electrical connector
    Hub and bearing
    Lower control arm bolts and the control arm


To install:

  1. Install or connect the following:
    Tighten the control arm nuts with the vehicle unsupported and resting on the wheels at the normal trim height.

    Lower control arm to the frame.

    Bolts and the nuts
    Hub and bearing
    ABS electrical connector
    Tie rod
    Stabilizer link assembly to the control arm
    Height sensor
    Rear wheel

  3. Lower the vehicle and tighten the control arm nuts to 78 ft. lbs. (106 Nm).