Pickup 1997

Removal & Installation

Print

At this time the manufacturer does not provide removal and installation procedures for this component. The following procedure is a guideline and may differ from the vehicle you are servicing.


NOTE
Whenever the negative battery cable is disconnected the following components will require resetting, the Radio presets and clock.

  1. Before servicing the vehicle, refer to the Precautions Section.
    NOTE
    If working near and/or around the SRS system and components, be sure to disable the SRS system. After disabling the system wait three minutes or more before servicing the vehicle.

  2.  
  3. Disconnect both cables from the battery.
    NOTE
    Disconnect the negative battery cable, first.

  4.  
  5. Remove the battery cover.
  6.  
  7. Remove the battery clamp nuts and battery clamp.
  8.  
  9. Remove the battery.
  10.  

To install:

  1. Installation is the reverse of the removal procedure.
  2.  
  3. Perform reconnect/relearn procedures.
    NOTE
    Connect the positive battery cable first.

  4.  
  5. Tighten the battery terminal nut to 31 inch lbs. (3.5 Nm). Tighten the clamp nuts to 11 ft. lbs.3 (3.5 Nm).
  6.  

 
label.common.footer.alt.autozoneLogo