Pickup 1997

Driven Disc & Pressure Plate

Print

Removal & Installation



  1. Before servicing the vehicle, refer to the Precautions Section.
    NOTE
    If working near and/or around the SRS system and components, be sure to disable the SRS system. After disabling the system wait three minutes or more before servicing the vehicle. Disconnect the air bag module connector.



    Click image to see an enlarged view

    Fig. Air bag module connector location

  2.  
  3. Disconnect the negative battery cable.
  4.  
  5. Remove the transmission.
  6.  
  7. Remove the clutch pressure plate retaining bolts.
  8.  
  9. Remove the pressure plate and disc.

    Click image to see an enlarged view

    Fig. Clutch disc and related components



    Click image to see an enlarged view

    Fig. Clutch release mechanism and related components

  10.  

To install:


NOTE
Be sure to use new fasteners, as required.

  1. Installation is the reverse of the removal procedure.
  2.  
  3. Tighten the bolts in sequence and in two steps. Step one 7-14 ft. lbs. Step two 16-22 ft. lbs.

    Click image to see an enlarged view

    Fig. Clutch disc and pressure plate tightening sequence

  4.  
  5. Using the CONSULT-III diagnostic tool, or equivalent, perform the SRS self diagnostic test and any reconnect/relearn procedures, as required.
  6.  

 
label.common.footer.alt.autozoneLogo