Pickup 1997

Master Cylinder

Print

Overhaul



Specific to:

Nissan Pickup 1996-1997

At this time the manufacturer does not provide removal and installation procedures for this component, refer to the illustration as required. Before servicing the vehicle, refer to the Precautions Section.


NOTE
If working near and/or around the SRS system and components, be sure to disable the SRS system. After disabling the system wait three minutes or more before servicing the vehicle. Disconnect the air bag module connector. Disconnect the negative battery cable. Once repair work is completed, use the CONSULT-III diagnostic tool, or equivalent, perform the SRS self diagnostic test and any reconnect/relearn procedures, as required.



Click image to see an enlarged view

Fig. Air bag module connector location



Click image to see an enlarged view

Fig. Clutch master cylinder exploded view

Removal & Installation



Specific to:

Nissan Pickup 1996-1997

At this time the manufacturer does not provide removal and installation procedures for this component. The following procedure is a guideline and may differ from the vehicle you are servicing.

  1. Before servicing the vehicle, refer to the Precautions Section.
    NOTE
    If working near and/or around the SRS system and components, be sure to disable the SRS system. After disabling the system wait three minutes or more before servicing the vehicle. Disconnect the air bag module connector.



    Click image to see an enlarged view

    Fig. Air bag module connector location

  2.  
  3. Disconnect the negative battery cable.
  4.  
  5. Remove the hydraulic lines from the master cylinder being careful not to damage the compression fitting.
  6.  
  7. Remove the two bolts holding the clutch master cylinder to the engine compartment.
    WARNING
    Brake fluid dissolves paint. Do not allow it to drip onto the body when removing the master cylinder. If any does get on the paint, wipe it off immediately.



    Click image to see an enlarged view

    Fig. Clutch master cylinder exploded view

  8.  

To install:


NOTE
Be sure to use new fasteners, as required.

  1. Installation is the reverse of the removal procedure.
  2.  
  3. Bleed the system and adjust the clutch pedal.
  4.  
  5. Using the CONSULT-III diagnostic tool, or equivalent, perform the SRS self diagnostic test and any reconnect/relearn procedures, as required.
  6.  

 
label.common.footer.alt.autozoneLogo