Pickup 1997

Air Intake System

Print

Air Cleaner Element (Filter)



Specific to:

Nissan Pickup 1996-1997

At this time the manufacturer does not provide removal and installation procedures for this component. The following procedure is a guideline and may differ from the vehicle you are servicing.

  1. Before servicing the vehicle, refer to the Precautions Section.
    NOTE
    If working near and/or around the SRS system and components, be sure to disable the SRS system. After disabling the system wait three minutes or more before servicing the vehicle. Disconnect the air bag module connector.



    Click image to see an enlarged view

    Fig. Air bag module connector location

  2.  
  3. Disconnect the negative battery cable.
  4.  
  5. Remove the top cover retaining clips and/or fasteners.
  6.  
  7. Remove and discard the element.

    Click image to see an enlarged view

    Fig. Air cleaner element and related components

  8.  

To install:


NOTE
Be sure to use new fasteners, as required.

  1. Installation is the reverse of the removal procedure.
  2.  
  3. Using the CONSULT-III diagnostic tool, or equivalent, perform the SRS self diagnostic test and any reconnect/relearn procedures, as required.
  4.  

Removal & Installation



Specific to:

Nissan Pickup 1996-1997

At this time the manufacturer does not provide removal and installation procedures for this component. The following procedure is a guideline and may differ from the vehicle you are servicing.

  1. Before servicing the vehicle, refer to the Precautions Section.
    NOTE
    If working near and/or around the SRS system and components, be sure to disable the SRS system. After disabling the system wait three minutes or more before servicing the vehicle. Disconnect the air bag module connector.



    Click image to see an enlarged view

    Fig. Air bag module connector location

  2.  
  3. Disconnect the negative battery cable.
  4.  
  5. Disconnect all hoses, ducts and vacuum tubes from the air cleaner assembly.
  6.  
  7. Most models also utilize side clips to further secure the top of the assembly. Simply pull the wire tab and release the clip.
  8.  
  9. Remove the cover and lift out the filter element.
  10.  
  11. Remove any side mount brackets and/or retaining bolts, then lift off the air cleaner assembly.
  12.  
  13. Replace the filter element. Wipe clean all surfaces of the air cleaner housing and cover. Check the condition of the mounting gasket and replace if it appears worn or broken.

    Click image to see an enlarged view

    Fig. Air cleaner assembly and related components

  14.  

To install:


NOTE
Be sure to use new fasteners, as required.

  1. Installation is the reverse of the removal procedure.
  2.  
  3. Using the CONSULT-III diagnostic tool, or equivalent, perform the SRS self diagnostic test and any reconnect/relearn procedures, as required.
  4.  

 
label.common.footer.alt.autozoneLogo