Pilot 2006-2008

Bleeding the ABS System

Print

Specific to:

Honda Pilot 2006-2008


WARNING
Do not reuse the drained fluid. Use only clean Honda DOT 3 Brake Fluid from an unopened container. Using a non-Honda brake fluid can cause corrosion and shorten the life of the system.


WARNING
Make sure no dirt or other foreign matter is allowed to contaminate the brake fluid.


WARNING
Do not spill brake fluid on the vehicle, it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.

  1. The reservoir on the master cylinder must be at the MAX (upper) level mark at the start of the bleeding procedure and checked after bleeding each brake caliper. Add fluid as required.
  2.  
  3. Make sure the brake fluid level in the reservoir is at the MAX (upper) level line.
  4.  
  5. Slide a piece of clear plastic hose over the first bleed screw, and submerge the other end in a container of new brake fluid.
  6.  
  7. Have someone slowly pump the brake pedal several times, and then apply steady pressure.
  8.  
  9. Starting at the left-front, loosen the brake bleed screw to allow air to escape from the system. Then tighten the bleed screw securely.
  10.  
  11. Repeat the procedure for each wheel in the sequence shown following until air bubbles no longer appear in the fluid.
  12.  
  13. Refill the master cylinder reservoir to the MAX (upper) level line.

    Click image to see an enlarged view

    Fig. Brake bleeding sequence

  14.  

 
label.common.footer.alt.autozoneLogo