Pilot 2006-2008

Alternator

Print

Removal & Installation



  1. Before servicing the vehicle, refer to the Precautions Section.
    NOTE
    Be sure that you have the anti-theft codes for the audio system and navigation system, if equipped. Record the audio presets.

  2.  
  3. Before servicing the vehicle, refer to the Precautions Section.
  4.  
  5. Turn the ignition switch OFF.
  6.  
  7. Disconnect and isolate the negative battery cable. Wait 3 minutes for the system capacitor to discharge before performing any service.
  8.  
  9. Disconnect the positive battery cable.
  10.  
  11. Remove the engine cover.

    Click image to see an enlarged view

    Fig. Engine cover



    Click image to see an enlarged view

    Fig. Drive belt and related components-J35A9 engine



    Click image to see an enlarged view

    Fig. Drive belt and related components-J35Z1 engine

  12.  
  13. Move the auto tensioner using the drive belt removal tool to relieve the tension on the drive belt. Remove the drive belt.
  14.  
  15. Remove the alternator harness clamp and bracket.
  16.  
  17. Disconnect the electrical connector and the BLK wire from the alternator.
  18.  
  19. Remove the mounting bolt and alternator bracket mounting bolt. Remove the alternator from the vehicle.

    Click image to see an enlarged view

    Fig. Alternator and related components



    Click image to see an enlarged view

    Fig. Alternator-exploded view

  20.  

To install:

  1. Installation is the reverse of the removal procedure.
    NOTE
    The power window reset procedure must be performed when disconnecting the battery, removing the No. 1 (20 amp) fuse in the passenger-s under dash fuse/relay box, disconnecting the 18P connector from the power window control unit, removing the window regulator, glass or glass run channel and disconnecting the driver-s door wire harness.

  2.  
  3. Turn the ignition switch OFF.
  4.  
  5. Turn the ignition switch ON (II).
  6.  
  7. Move the driver-s power window all the way down by holding the driver-s power window switch firmly down to the second detent. When the window reaches the bottom, hold the driver-s power window switch in the AUTO DOWN position for two seconds.
  8.  
  9. Move the driver-s power window all the way up without stopping by holding the driver-s power window switch firmly up to the second detent. When the window reaches the top, hold the driver-s power window switch in the AUTO UP position for two seconds.
    NOTE
    If the power window does not work in AUTO, repeat the procedure.

  10.  

 
label.common.footer.alt.autozoneLogo