Pilot 2006-2008

Ignition Coil Module

Print

Removal & Installation



  1. Before servicing the vehicle, refer to the Precautions Section.
    NOTE
    Be sure that you have the anti-theft codes for the audio system and navigation system, if equipped. Record the audio presets.

  2.  
  3. Before servicing the vehicle, refer to the Precautions Section.
  4.  
  5. Turn the ignition switch OFF.
  6.  
  7. Disconnect and isolate the negative battery cable. Wait 3 minutes for the system capacitor to discharge before performing any service.
  8.  
  9. Disconnect the positive battery cable.
  10.  
  11. Remove the engine cover.

    Click image to see an enlarged view

    Fig. Engine cover

  12.  
  13. Disconnect the ignition coil connectors. Remove the front bank of ignition coils.

    Click image to see an enlarged view

    Fig. Ignition coils and related components-front bank



    Click image to see an enlarged view

    Fig. Ignition coils and related components-rear bank

  14.  
  15. Disconnect the ignition coil connectors. Remove the rear bank of ignition coils.
  16.  

To install:

  1. Installation is the reverse of the removal procedure.
    NOTE
    The power window reset procedure must be performed when disconnecting the battery, removing the No. 1 (20 amp) fuse in the passenger-s under dash fuse/relay box, disconnecting the 18P connector from the power window control unit, removing the window regulator, glass or glass run channel and disconnecting the driver-s door wire harness.

  2.  
  3. Turn the ignition switch OFF.
  4.  
  5. Turn the ignition switch ON (II).
  6.  
  7. Move the driver-s power window all the way down by holding the driver-s power window switch firmly down to the second detent. When the window reaches the bottom, hold the driver-s power window switch in the AUTO DOWN position for two seconds.
  8.  
  9. Move the driver-s power window all the way up without stopping by holding the driver-s power window switch firmly up to the second detent. When the window reaches the top, hold the driver-s power window switch in the AUTO UP position for two seconds.
    NOTE
    If the power window does not work in AUTO, repeat the procedure.

  10.  

 
label.common.footer.alt.autozoneLogo