Removal & Installation
- Before servicing the vehicle, refer to the Precautions Section.
- As required, remove a small amount of brake fluid from the reservoir using a suction pump.
- Raise and safely support the vehicle.
- Remove the tire and wheel assembly.
Remove the flange bolt while holding the caliper pin with a wrench.
WARNINGBe careful not to damage the pin boot, and pivot the caliper up and out of the way.
- Remove the pad shims and pads. Remove the pad retainers.
Install the pad retainers.
NOTEApply molybdenum brake grease to both surfaces of the shims and the back of the disc brake pads, prior to installation.
Install the pads and shims. See illustration for proper positioning.
- Use a suitable tool to push caliper piston into its bore and enable the caliper to fit over the pads. Lubricate the piston boot with silicon grease. Avoid twisting the boot.
- Continue the installation in the reverse order of the removal procedure.
- Add brake fluid to the master cylinder reservoir. Depress the brake pedal several times to seat the pads. Bleed the brakes if necessary.