Pontiac Fiero 1984-1988 Repair Guide

Flashers

Print

REMOVAL & INSTALLATION



Turn Signals


Click image to see an enlarged view

Fig. Fig. 1 The turn signal flasher is located on the left hand side of the steering column support



Click image to see an enlarged view

Fig. Fig. 2 Sample diagram-how to read and interpret wiring



Click image to see an enlarged view

Fig. Fig. 3 Common wiring diagram symbols

  1. Disconnect the negative (-) battery cable.
  2.  
  3. The turn signal flasher is located to the left of the steering column support bracket under the instrument panel.
  4.  
  5. Remove the electrical connector and slide the flasher assembly out of the bracket.
  6.  

To install:

  1. Reconnect the electrical connector and position the flasher into the bracket. Connect the negative (-) battery cable and turn the ignition key to the ON position. Operate the turnsignal switch in both directions to check for proper flasher operation.
  2.  

Hazard (4-way)
  1. Disconnect the negative (-) battery cable.
  2.  
  3. The hazard flasher is located in the convenience center at the RH side of the A/C and heater module under the instrument panel. Refer to the "Convenience Center" procedures in this section.
  4.  
  5. Disconnect the electrical connector and gently pull the flasher straight out of the convenience center.
  6.  

 
label.common.footer.alt.autozoneLogo