Pontiac Fiero 1984-1988 Repair Guide

Console

Print

REMOVAL & INSTALLATION



Shift Plate Assembly


Click image to see an enlarged view

Fig. Fig. 1 Exploded view of the console assembly components

  1. Remove the shift knob, ash tray, four attaching bolts and the shift plate.
  2.  
  3. Install in reverse order.
  4.  

Front Console Pad
  1. Remove the shifter knob and shifter trim plate.
  2.  
  3. Remove the front trim plate.
  4.  
  5. Remove the front trim pad attaching screws and the pad assembly.
  6.  
  7. Install in reverse order.
  8.  

Rear Console Pad
  1. Remove the shifter trim plate and move out of the way.
  2.  
  3. Remove the rear pad attaching screws.
  4.  
  5. Disconnect the cigar lighter wiring and remove the lighter.
  6.  
  7. Remove the rear console pad.
  8.  

To install:

  1. Position the cigar lighter into the pad assembly and connect the wire.
  2.  
  3. Install the rear pad attaching screws.
  4.  
  5. Install the shifter trim plate.
  6.  

Console Support Assembly


Click image to see an enlarged view

Fig. Fig. 2 Exploded view of the console support assembly



Click image to see an enlarged view

Fig. Fig. 3 Unfasten the shifter trim panel retainers and remove it



Click image to see an enlarged view

Fig. Fig. 4 Remove the power window and mirror switch retainers ...



Click image to see an enlarged view

Fig. Fig. 5 ... then lift the switch assembly up and disengage the electrical connections

  1. Remove the shifter knob, shifter trim panel and power window and mirror switches, if so equipped.
  2.  
  3. Remove the parking brake cable.
  4.  
  5. Disconnect the shift cable.
  6.  
  7. Remove the front trim and pad assembly.
  8.  
  9. Remove the rear trim and pad assembly.
  10.  
  11. Remove the twelve carpet clips and carpet support.
  12.  
  13. Remove the ALDL diagnostic connection.
  14.  
  15. Remove the two mounting screws on the sides of the support assembly. Remove the front reinforcement.
  16.  
  17. Remove the heater control and radio assemblies.
  18.  
  19. Remove the console support assembly.
  20.  

To install:

  1. Install the console support assembly (loosely).
  2.  
  3. Install the radio and heater control.
  4.  
  5. Install the two console side mounting screws.
  6.  
  7. Install the front reinforcement and the carpet support and clips.
  8.  
  9. Install the ALDL diagnostic connection.
  10.  
  11. Install the shifter and parking brake cables.
  12.  
  13. Install the rear pad assembly.
  14.  
  15. Install the power window and mirror switches and trim plate, if so equipped.
  16.  
  17. Install the front pad and trim plate assemblies.
  18.  
  19. Install the shifter trim plate and knob.
  20.  
  21. Start the vehicle and check for proper accessary, parking brake and shifter operation.
  22.  

 
label.common.footer.alt.autozoneLogo