Honda CRV/Odyssey 1995-2000 Repair Information

Fuel Pressure Regulator

Print

REMOVAL & INSTALLATION




CAUTION
Observe all applicable safety precautions when working around fuel. Whenever servicing the fuel system, always work in a well ventilated area. Do not allow fuel spray or vapors to come in contact with a spark or open flame. Keep a dry chemical fire extinguisher near the work area. Always keep fuel in a container specifically designed for fuel storage; also, always properly seal fuel containers to avoid the possibility of fire or explosion.

  1. Properly relieve the fuel system pressure, as outlined earlier in this section.
  2.  
  3. Disconnect the negative battery cable.
  4.  
  5. Detach the vacuum hose from the fuel pressure regulator.
  6.  
  7. Unfasten the two fuel pressure regulator retaining bolts.
  8.  
  9. Remove the fuel pressure regulator and the O-rings. Discard the O-rings.
  10.  

See Figure 1

Click image to see an enlarged view

Fig. Fig. 1: Cross-sectional views of the fuel pressure regulator in both the open and closed positions

To install:
  1. Lubricate the new O-rings with light engine oil.
  2.  
  3. Position a new O-ring onto the fuel pressure regulator.
  4.  
  5. Place the fuel pressure regulator into position and install the retainers.
  6.  
  7. Attach the vacuum line to the fuel pressure regulator.
  8.  
  9. Connect the negative battery cable.
  10.  
  11. Run the engine at idle for 2 minutes, then turn the engine OFF and check for fuel leaks and proper operation.
  12.  

 
label.common.footer.alt.autozoneLogo