Protege 1999-2000

Removal & Installation

Print

  1. Disconnect the negative battery cable.
  2.  
  3. Disconnect the air mix and airflow mode wires from each wire clamp and link.
  4.  
  5. Remove the center panel.
  6.  
  7. Remove the screws and the climate control unit
  8.  

To install:

Click image to see an enlarged view

Fig. Pass each wire through the following routes then connect to each unit-Protégé

  1. Install the climate control unit to the center panel.
  2.  
  3. Pass each wire through the following routes then connect to each unit.
  4.  
  5. Connect the climate control unit connectors.
  6.  
  7. Install the center panel.
  8.  
  9. Adjust the air mix wire as follows:
    1. Set the temperature control dial at MAX COLD.
    2.  
    3. Set the air mix link to MAX COLD in the direction of the arrow and insert a screwdriver into the set hole.
    4.  
    5. Connect the air mix wire to the air mix link.
    6.  
    7. Clamp the air mix wire to wire clamp.
    8.  
    9. Verify that the temperature control dial moves its full stroke.

      Click image to see an enlarged view

      Fig. Adjusting the air mix wire-Protégé

    10.  

  10.  
  11. Adjust the airflow mode wire as follows:
    1. Set the airflow mode control dial at defroster.
    2.  
    3. Set the airflow mode link to defroster in the direction of the arrow and insert a screwdriver into the set hole.
    4.  
    5. Connect the airflow mode wire to the airflow mode link.
    6.  
    7. Clamp the airflow mode wire to wire clamp.
    8.  
    9. Verify that the airflow mode control dial moves its full stroke.

      Click image to see an enlarged view

      Fig. Adjusting the airflow mode wire-Protégé

    10.  

  12.  
  13. Connect the negative battery cable.
  14.  

 
label.common.footer.alt.autozoneLogo