Protege 1999-2000

Mirrors

Print

Power Mirrors



Diagnosis & Testing
  1. Apply battery positive voltage to the power outer mirror terminals and inspect the operation of the power outer mirror.
  2.  
  3. Apply battery voltage to terminal B and ground to terminal D. The mirror should go up.
  4.  
  5. Apply battery voltage to terminal D and ground to terminal B. The mirror should go down.
  6.  
  7. Apply battery voltage to terminal F and ground to terminal D. The mirror should go left.
  8.  
  9. Apply battery voltage to terminal D and ground to terminal F. The mirror should go right.
  10.  
  11. If not as specified, replace the power outer mirror.

    Click image to see an enlarged view

    Fig. Power mirror motor terminals-Protégé

  12.  

Removal & Installation
Mirror Motor

Specific to:

Mazda Protege 1999-2003

Mazda Protege5 2002-2003

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the inner garnish.
  4.  
  5. Remove the regulator handle if equipped.
  6.  
  7. Remove screws and the fastener.
  8.  
  9. Slide the pull handle cover toward the front of the vehicle, then disengage tab from the front door trim.
  10.  
  11. Remove the screws.
  12.  
  13. Disengage clips using a fastener remover from the body.
  14.  
  15. Pull the front door trim upward, then disengage the pins from the body.
  16.  
  17. Extract the inner handle from the front door trim.
  18.  
  19. Disconnect the power window main switch connector (driver-s side).
  20.  
  21. Disconnect the power window sub switch connector (passenger-s side).

    Click image to see an enlarged view

    Fig. Exploded view of the door trim-Protégé

  22.  
  23. Peel back the corner of the screen at the mirror location.
  24.  
  25. Unplug the connector, remove the nuts and the mirror.
  26.  

To install:

  1. Installation is the reverse of removal.
  2.  

Mirror Switch

Specific to:

Mazda Protege 1999-2003

Mazda Protege5 2002-2003

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the inner garnish.
  4.  
  5. Remove the regulator handle if equipped.
  6.  
  7. Remove screws and the fastener.
  8.  
  9. Slide the pull handle cover toward the front of the vehicle, then disengage tab from the front door trim.
  10.  
  11. Remove the screws.
  12.  
  13. Disengage clips using a fastener remover from the body.
  14.  
  15. Pull the front door trim upward, then disengage the pins from the body.
  16.  
  17. Extract the inner handle from the front door trim.
  18.  
  19. Push the clip from the reverse side of the trim to remove the switch panel
  20.  
  21. Disconnect the power window sub switch connector (passenger-s side).
  22.  
  23. Disconnect the electrical connections.
  24.  
  25. Remove the screws, then remove the power outer mirror switch.
  26.  

To install:

  1. Installation is the reverse of removal.

    Click image to see an enlarged view

    Fig. Exploded view of the door trim-Protégé

  2.  

 
label.common.footer.alt.autozoneLogo