Quest 1995-1996

Actuator

Print

Removal & Installation



Specific to:

Mercury Villager 1993-1998

Nissan Quest 1993-1998

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the hydraulic anti-lock actuator relay cover screw and remove the cover.
  4.  
  5. Disconnect the hydraulic anti-lock actuator electrical connector.
  6.  
  7. Using a flare nut wrench, disconnect the six brake lines from the hydraulic anti-lock actuator assembly and plug the lines.
  8.  
  9. Remove the three hydraulic anti-lock actuator assembly mounting nuts.
  10.  
  11. Remove the hydraulic anti-lock actuator assembly ground strap screw and remove the assembly from the vehicle.

    Click image to see an enlarged view

    Fig. Removing the hydraulic anti-lock actuator relay cover

  12.  

To install:

  1. Position the hydraulic anti-lock actuator assembly in the vehicle and install the ground strap screw.
  2.  
  3. Install the three hydraulic anti-lock actuator assembly mounting nuts and tighten them to 8-11 ft. lbs. (11-15 Nm).
  4.  
  5. Connect the six brake lines, starting the flare nuts by hand. Using a flare nut wrench, tighten the nuts to 11-13 ft. lbs. (15-18 Nm).
  6.  
  7. Connect the hydraulic anti-lock actuator electrical connector.
  8.  
  9. Install the hydraulic anti-lock actuator relay cover and cover screw.
  10.  
  11. Connect the negative battery cable.
  12.  
  13. Properly bleed the brake system.
  14.  

Specific to:

Mercury Villager 1993-2000

Nissan Quest 1993-2000


WARNING
Clean, high quality brake fluid is essential to the safe and proper operation of the brake system. You should always buy the highest quality brake fluid that is available. If the brake fluid becomes contaminated, drain and flush the system, then refill the master cylinder with new fluid. Never reuse any brake fluid. Any brake fluid that is removed from the system should be discarded. Also, do not allow any brake fluid to come in contact with a painted surface; it will damage the paint.


CAUTION
Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with the eyes and wash your hands thoroughly after handling brake fluid. If you do get brake fluid in your eyes, flush your eyes with clean, running water for 15 minutes. If eye irritation persists, or if you have taken brake fluid internally, IMMEDIATELY seek medical assistance.

 
label.common.footer.alt.autozoneLogo