Quest 1995-1996

Removal & Installation

Print

Specific to:

Mercury Villager 1993-1995

Nissan Quest 1993-1995

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the plastic clip and four screws from the passenger-s side lower instrument panel cover and remove the cover.
  4.  
  5. Disconnect the blower motor electrical connector.
  6.  
  7. Remove the blower motor housing vent tube.
  8.  
  9. Remove the three blower motor screws and remove the motor.
  10.  
  11. To remove the fan from the blower motor, insert a right angle pick under the retaining clip and press upward on the tangs to release the clip. Slide the fan off of the blower motor shaft.
  12.  
  13. The installation is the reverse of removal.

    Click image to see an enlarged view

    Fig. Don-t forget to remove the side plastic retainer when removing the passenger-s side lower instrument panel cover



    Click image to see an enlarged view

    Fig. After removing the clip and screws, pull the cover away from the instrument panel to release the metal clips



    Click image to see an enlarged view

    Fig. Disconnect the blower motor electrical connector



    Click image to see an enlarged view

    Fig. After removing the three screws, remove the blower motor

  14.  

Specific to:

Mercury Villager 1996-1998

Nissan Quest 1996-1998

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the four lower center console cover plastic clips and remove the cover.
  4.  
  5. Remove the plastic clip from the side of the glove compartment assembly. Remove the two lower screws, two center bolts, two upper screws, and the screw at the instrument panel bracket. Separate the glove compartment from the instrument panel, disconnect the electrical connector from the latch, and remove the glove compartment.
  6.  
  7. Remove the four instrument panel lower reinforcement bolts and remove the reinforcement.
  8.  
  9. Disconnect the blower motor electrical connector.
  10.  
  11. Remove the blower motor housing vent tube.
  12.  
  13. Remove the A/C blower motor speed control screw and position the speed control aside.
  14.  
  15. Remove the three blower motor screws and remove the motor.
  16.  
  17. To remove the fan from the blower motor, insert a right angle pick under the retaining clip and press upward on the tangs to release the clip. Slide the fan off of the blower motor shaft.
  18.  
  19. The installation is the reverse of removal.

    Click image to see an enlarged view

    Fig. Bottom view of the A/C evaporator and blower motor assembly-1996-98 vehicles

  20.  

 
label.common.footer.alt.autozoneLogo