Quest 1995-1996

Hood

Print

Alignment



Specific to:

Mercury Villager 1993-2000

Nissan Quest 1993-2000

  1. The hood can be adjusted fore-and-aft and side-to-side by loosening the four hood hinge-to-hood bolts.
  2.  
  3. Position the hood so that the distance between the hood and front fenders are equal on both sides. Tighten the hood hinge-to-hood bolts to 9-12 ft. lbs. (13-16 Nm).
  4.  

Removal & Installation



Specific to:

Mercury Villager 1993-2000

Nissan Quest 1993-2000


NOTE
Hood removal requires the aid of an assistant.

  1. Disconnect the negative battery cable.
  2.  
  3. Disconnect the engine compartment lamp electrical connector.
  4.  
  5. If the hood is going to be reinstalled, mark the hood around the hinges to ease installation.
  6.  
  7. Support the hood and remove the four hood hinge-to-hood bolts. Remove the hood from the vehicle.

    Click image to see an enlarged view

    Fig. Removing the hood hinge-to-hood bolts

  8.  

To install:

  1. The installation is the reverse of removal. Adjust the hood if needed. When installing the hood hinge-to-hood bolts, tighten them to 115-142 inch lbs. (13-16 Nm).
  2.  

 
label.common.footer.alt.autozoneLogo