Quest 1995-1996

Instrument Cluster

Print

Removal & Installation



Conventional Cluster

Specific to:

Mercury Villager 1993-1998

Nissan Quest 1993-1998

  1. Disconnect the negative battery cable.
  2.  
  3. Apply the parking brake and block the rear wheels.
  4.  
  5. Turn the ignition switch to the OFF position.
  6.  
  7. Shift the gearshift lever to the 1 position.
  8.  
  9. Position the steering wheel in the full-down position.
  10.  
  11. Remove the two instrument cluster bezel screws.
  12.  
  13. Separate the instrument cluster bezel from the instrument panel enough to gain access to the electrical connectors. Disconnect the following electrical connectors:

    Rear window wiper/washer switch
     
    Rear window defogger switch
     
    Hazard warning flasher switch
     
    Power E-AT switch, if equipped
     
    Security indicator lamp, if equipped
     
    Cruise control ON/OFF switch
     
    Headlamp switch
     

  14.  
  15. Remove the instrument cluster bezel with the switches attached.
  16.  
  17. Remove the four instrument cluster screws and separate the instrument cluster from the instrument panel.
  18.  
  19. Position the cluster to gain access to the gearshift indicator. Remove the gearshift indicator from the cluster.
  20.  
  21. Disconnect the electrical connectors from the instrument cluster and remove the cluster.
  22.  
  23. The installation is the reverse of removal.
  24.  

Specific to:

Mercury Villager 1993-1998

Nissan Quest 1993-1998

  1. Disconnect the negative battery cable.
  2.  
  3. Apply the parking brake and block the rear wheels.
  4.  
  5. Turn the ignition switch to the OFF position.
  6.  
  7. Shift the gearshift lever to the 1 position.
  8.  
  9. Position the steering wheel in the full-down position.
  10.  
  11. Carefully pull the rear window wiper/washer switch assembly from the instrument panel, disconnect the electrical connector, and remove the assembly.
  12.  
  13. Carefully pull the rear window defogger switch assembly from the instrument panel, disconnect the electrical connector, and remove the assembly.
  14.  
  15. Carefully pull the hazard warning flasher switch assembly from the instrument panel, disconnect the electrical connector, and remove the assembly.
  16.  
  17. If equipped with a Power E-AT switch, carefully pull the switch assembly from the instrument panel, disconnect the electrical connector, and remove the assembly.
  18.  
  19. If equipped with a security indicator lamp, carefully pull the lamp assembly from the instrument panel, disconnect the electrical connector, and remove the assembly.
  20.  
  21. Carefully pull the cruise control ON/OFF switch assembly from the instrument panel, disconnect the electrical connector, and remove the assembly.
  22.  
  23. Carefully pull the headlamp switch assembly from the instrument panel, disconnect the electrical connectors, and remove the switch and bezel assembly.
  24.  
  25. Remove the two instrument cluster bezel and remove the bezel.
  26.  
  27. Remove the four instrument cluster screws and separate the instrument cluster from the instrument panel.
  28.  
  29. Position the cluster to gain access to the gearshift indicator. Remove the gearshift indicator from the cluster.
  30.  
  31. Disconnect the electrical connectors from the instrument cluster and remove the cluster.
  32.  
  33. The installation is the reverse of removal.
  34.  

 
label.common.footer.alt.autozoneLogo