Quest 1995-1996

Seating

Print

Power Seat Motor



Removal & Installation
  1. Remove the seat from the vehicle.
  2.  
  3. Place the seat upside down in a clean work area.
  4.  
  5. Detach the front seat adjuster motor electrical connector.
  6.  
  7. Remove the 2 cable holding bracket screws and the 2 brackets.
  8.  
  9. Remove the front seat adjuster motor screws.
  10.  
  11. Disengage the cables from the motor.
    NOTE
    Do not disassemble the front seat adjuster motor.

  12.  
  13. Remove the front seat adjuster motor from the front seat adjuster
  14.  

Removal & Installation



Center Bucket Seats

Specific to:

Mercury Villager 1993-2000

Nissan Quest 1993-2000

  1. Lift the seat back pivot handle and fold the seat back fully forward.
  2.  
  3. Lift the 2 seat release latches at the front of the seat to release the center bucket seat from the front floor anchors.
  4.  
  5. Tilt the center bucket seat backward and slide it off of the 2 rear floor anchors.
  6.  
  7. Remove the center bucket set from the vehicle
  8.  
  9. Installation is the reverse of the removal procedure.
  10.  

Front Seat

Specific to:

Mercury Villager 1993-2000

Nissan Quest 1993-2000

  1. Remove the under seat storage drawer, if removing the passenger seat.
    NOTE
    The front seat and front seat track assembly is removed separately from the front seat support assembly.

  2.  
  3. Move the seat to the fully forward position.
  4.  
  5. Remove the 2 rear front seat track-to-front seat bolts.
  6.  
  7. Move the front seat to the fully rear position. Remove the front seat track-to-front seat support assembly bolts.
  8.  
  9. If removing the driver front seat, detach the seat regulator control switch electrical connector, the lumbar support switch connector and the seat belt switch electrical connector, as necessary.
  10.  
  11. If removing the passenger front seat, detach the seat regulator control switch electrical connector, if equipped.
  12.  
  13. Remove the front seat and seat track assembly from the vehicle.
  14.  
  15. Installation is the reverse of the removal procedure. Torque the front seat track-to-front seat support bolts to 14-23 ft. lbs. (18-31 Nm).
  16.  

Rear Seat
Bench Seat
  1. Remove the center seat(s), if equipped.
  2.  
  3. Side the bench seat forward to the center row seating position.
  4.  
  5. Use a prytool to remove the cover caps from the front of the rear seat cushion latch cover. Remove the 2 rear seat bolts from the front of the rear seat cushion latch cover.
  6.  
  7. Lift the rear seat cushion floor cover on the back of the rear bench seat and remove the 2 inboard rear seat bolts and 2 outboard rear seat bolts.
  8.  
  9. Remove the bench seat from the vehicle through the body side door opening.
  10.  
  11. Installation is the reverse of the removal procedure.
  12.  

 
label.common.footer.alt.autozoneLogo