Quest 1995-1996



Specific to:

Mercury Villager 1993-2000

Nissan Quest 1993-2000

This test determines voltage available from the battery and should be the first step in any electrical troubleshooting procedure after visual inspection. Many electrical problems, especially on computer controlled systems, can be caused by a low state of charge in the battery. Excessive corrosion at the battery cable terminals can cause poor contact that will prevent proper charging and full battery current flow.

  1. Set the voltmeter selector switch to the 20V position.
  3. Connect the multimeter negative lead to the battery's negative (-) post or terminal and the positive lead to the battery's positive (+) post or terminal.
  5. Turn the ignition switch ON to provide a load.
  7. A well charged battery should register over 12 volts. If the meter reads below 11.5 volts, the battery power may be insufficient to operate the electrical system properly.

Voltage Drop

Click image to see an enlarged view

Fig. This voltage drop test revealed high resistance (low voltage) in the circuit

When current flows through a load, the voltage beyond the load drops. This voltage drop is due to the resistance created by the load and also by small resistances created by corrosion at the connectors and damaged insulation on the wires. The maximum allowable voltage drop under load is critical, especially if there is more than one load in the circuit, since all voltage drops are cumulative.

  1. Set the voltmeter selector switch to the 20 volt position.
  3. Connect the multimeter negative lead to a good ground.
  5. Operate the circuit and check the voltage prior to the first component (load).
  7. There should be little or no voltage drop in the circuit prior to the first component. If a voltage drop exists, the wire or connectors in the circuit are suspect.
  9. While operating the first component in the circuit, probe the ground side of the component with the positive meter lead and observe the voltage readings. A small voltage drop should be noticed. This voltage drop is caused by the resistance of the component.
  11. Repeat the test for each component (load) down the circuit.
  13. If a large voltage drop is noticed, the preceding component, wire or connector is suspect.