Quest 1995-1996

Rear Window Washer/Wiper Systems

Print

Removal & Installation



Wiper Blade & Arm

Specific to:

Mercury Villager 1993-2000

Nissan Quest 1993-2000

  1. Using a small screwdriver, depress the locking clip at the base of the wiper arm and blade assembly.
  2.  
  3. Pull up on the wiper blade and arm assembly to remove it from the pivot.
  4.  
  5. Disconnect the rear washer hose from the jet and remove the blade and arm assembly.
  6.  
  7. The installation is the reverse of removal.

    Click image to see an enlarged view

    Fig. Removing the rear wiper blade and arm assembly

  8.  

Wiper Motor

Specific to:

Mercury Villager 1993-2000

Nissan Quest 1993-2000

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the rear wiper arm and blade assembly.
  4.  
  5. Pull the cover off of the rear wiper motor shaft nut and remove the nut.
  6.  
  7. Remove the outer collar and seal from the shaft.
  8.  
  9. Remove the liftgate trim panel. Please refer to Body and Trim, Interior, Liftgate Panel, Removal and Installation for the procedure.
  10.  
  11. Carefully remove the plastic watershield by detaching it from the adhesive.
  12.  
  13. Disconnect the rear wiper motor electrical connector.
  14.  
  15. Remove the three rear wiper motor and bracket assembly bolts and remove the assembly.
  16.  
  17. Remove the inner collar from the wiper motor shaft.
  18.  
  19. Remove the two wiper motor-to-bracket bolts, slide the electrical connector from the bracket, and remove the bracket from the motor.
  20.  
  21. The installation is the reverse of removal.

    Click image to see an enlarged view

    Fig. Pull the cover off of the rear wiper motor shaft nut and remove the nut



    Click image to see an enlarged view

    Fig. Removing the wiper motor and bracket assembly bolts



    Click image to see an enlarged view

    Fig. Removing the wiper motor-to-bracket bolts

  22.  

Wiper Switch

Specific to:

Mercury Villager 1993-2000

Nissan Quest 1993-2000

  1. Disconnect the negative battery cable.
  2.  
  3. Carefully pull the rear window wiper switch assembly from the instrument panel.
  4.  
  5. Disconnect the rear window wiper switch electrical connector and remove the switch.
  6.  
  7. The installation is the reverse of removal.
  8.  

 
label.common.footer.alt.autozoneLogo