RX300 1999

Fuel Pump

Print

Removal & Installation





Click image to see an enlarged view

Fig. Fuel pump

  1. Before servicing the vehicle, refer to the precautions section.
  2.  
  3. Relieve the fuel system pressure.
  4.  
  5. Remove or disconnect the following:
    NOTE
    Loosen the fuel cap to relieve any fuel pressure within the tank.



    Negative battery cable
     
    Left-hand rear seat assembly
     
    Floor service hole by pulling back the carpet; then, remove the 4 screws
     
    Fuel pump and sender gauge connector
     



    Fuel pipe union bolt and both gaskets
     
    Fuel pump outlet pipe
     
    Return vent hose from the fuel pump
     
    8 fuel pump bolts and the pump assembly from the tank
     

  6.  

To install:

  1. Install or connect the following:

    Fuel pump to the fuel tank. Tighten the 8 bolts to 31 inch lbs. (3.5 Nm).
     
    Return vent hose to the fuel pump
     
    Outlet pipe to the fuel pump, using new gaskets. Tighten the union bolts to 22 ft. lbs. (29 Nm).
     
    Fuel pump and sender gauge connector
     
    Floor hole cover with the 4 screws
     
    Carpet
     
    Left rear seat assembly
     
    Negative battery cable
     
    Fuel cap
     

  2.  
  3. Start the vehicle and check for leaks.
  4.  

 
label.common.footer.alt.autozoneLogo