RX300 1999

Removal & Installation

Print



Click image to see an enlarged view

Fig. Steering gear mounting

  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2.  
  3. Remove the steering wheel.
  4.  
  5. Remove or disconnect the following:
    NOTE
    Wait at least 90 seconds before working on the vehicle to allow the Supplemental Restraint System (SRS) system to disarm.



    Negative battery cable
     



    Right and left side fender apron seals
     
    Right and left tie rod ends
     

  6.  
  7. Place matchmarks on the intermediate shaft.
  8.  
  9. Remove or disconnect the following:

    Pinch bolt and the intermediate shaft out from under the vehicle
     
    Power steering line clamp
     
    Pressure and feed lines
     
    Stabilizer bar, unbolt it but do not remove it
     
    Heated Oxygen (HO 2 ) sensor
     
    Both gear assembly set bolts and nuts, by lifting the stabilizer bar
     
    Gear assembly from the left side of the vehicle
     

  10.  

To install:

  1. Install or connect the following:
    WARNING
    Be careful not to damage the power steering lines.



    Gear assembly to the left side of the vehicle
     



    Tighten the gear assembly set bolts and nuts to 134 ft. lbs. (181 Nm), by lifting the stabilizer bar
     
    HO 2 sensor
     
    Stabilizer bar. Tighten the bolt to 14 ft. lbs. (19 Nm) and the nut to 29 ft. lbs. (39 Nm).
     
    Pressure and feed return lines. Tighten them to 18 ft. lbs. (25 Nm).
     
    Line clamps. Tighten the nut to 84 inch lbs. (10 Nm).
     
    Intermediate shaft, by aligning the joint and main shaft matchmarks. Tighten to 26 ft. lbs. (35 Nm).
     
    Tie rod ends
     
    Fender apron seals. Securely tighten the bolts.
     

  2.  
  3. Remove or disconnect the following:

    Steering wheel pad
     
    Steering wheel
     

  4.  
  5. Position the front wheels facing straight-ahead. Do this with the front of the vehicle on jackstands.
  6.  
  7. Center the spiral cable.
  8.  
  9. Install the steering wheel at the straight-ahead position. Temporarily tighten the wheel set nut. Attach the wiring.
  10.  
  11. Bleed the power steering system.
  12.  
  13. Check the steering wheel center point. Tighten the steering nut to 26 ft. lbs. (35 Nm).
  14.  
  15. Check and/or adjust the front wheel alignment.
  16.  

 
label.common.footer.alt.autozoneLogo