Ram 1500, 2500, 3500, 2WD and 4WD, 2001-2005

Torsion Bar

Print

Removal & Installation



  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Loosen the adjustment bolt to remove spring load. Note the number of turns for installation.
  4.  
  5. Remove or disconnect the following:

    Adjustment bolt, swivel and bearing
     
    Torsion bar and anchor
     

  6.  
  7. Separate the torsion bar and anchor.
  8.  

To install:

  1. Assemble the torsion bar and anchor.
  2.  
  3. Install or connect the following:

    Torsion bar and anchor
     
    Adjustment bolt, swivel and bearing
     

  4.  
  5. Tighten the adjustment bolt the recorded number of turns.
  6.  

 
label.common.footer.alt.autozoneLogo