Removal & Installation
- Before servicing the vehicle, refer to the Precautions Section.
Remove or disconnect the following:
Negative battery cable
Loosen the rocker shaft bolts as follows: center, center left, center right, left, right.
NOTEThe rocker shaft assemblies are not interchangeable. The intake side is marked -I- . The shorter pushrods are used on the intake side.
Install or connect the following:
WARNINGDo not rotate the crankshaft during or immediately after rocker shaft installation. Allow the roller tappets to leakdown for about 5 minutes.
Cylinder head covers. Torque the fasteners to 70 inch lbs.