Ram Truck 1500, 2500 & 3500 (2006-2008)

Injection Timing

Print

Adjustment



5.9L & 6.7L Engines
  1. Perform the following phasing procedure anytime the injection pump has been removed and re-installed.
  2.  
  3. Locate the end of the fuel injection pump shaft. Two numbers (750 and 0) are stamped into the end of the shaft.
  4.  
  5. Rotate the injection pump shaft until the number 5 (located in the center of number 750) is positioned at 9 o'clock.
  6.  
  7. Position injection pump to mounting flange on gear housing while aligning injection pump shaft through back of injection pump gear. Be sure the number 5 is still at the 9 o'clock position.
  8.  
  9. Bring the engine to TDC position. Do this by rotating the crankshaft until the TDC mark on the crankshaft damper is at 12 o'clock position. It does not matter if cylinder number 1 or number 6 is at TDC. Again, check to be sure the number 5 is still at the 9 o'clock position. Rotate pump shaft accordingly.

    Click image to see an enlarged view

    Fig. Two numbers (750 and 0) at end of injection pump shaft shown



    Click image to see an enlarged view

    Fig. Number 5 shown at the 9 o'clock position

  10.  

 
label.common.footer.alt.autozoneLogo