Ram Truck 1500, 2500 & 3500 (2006-2008)

Removal & Installation

Print

The fuel filter is located in the fuel tank. If the electrical fuel pump, primary inlet filter, fuel filter or fuel pressure regulator require service, the fuel pump module must be removed.

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Relieve the fuel system pressure.
  4.  
  5. Remove or disconnect the following:

    Negative battery cable
     
    Fuel tank
     

  6.  
  7. Pull the filter/regulator out of the rubber grommet. Cut the hose clamp and remove the fuel line.

    Click image to see an enlarged view

    Fig. Pull and twist the filter/regulator to remove it from the top of the fuel pump module

  8.  

To install:

  1. Install the filter/regulator with a new clamp and push it into the rubber grommet.
  2.  
  3. Install or connect the following:

    Fuel tank
     
    Negative battery cable
     

  4.  
  5. Start the engine and check for leaks.
  6.  

 
label.common.footer.alt.autozoneLogo