Ram Truck 1500, 2500 & 3500 (2006-2008)

Removal & Installation

Print

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Remove fuel pump module from fuel tank. Refer to fuel pump module removal and installation.
  4.  
  5. Disconnect 4-wire electrical connector from fuel pump module. Separate the necessary sending unit wiring from connector using terminal pick removal tool.
  6.  
  7. To remove sending unit from pump module, lift on plastic locking tab while sliding sending unit tracks.

    Click image to see an enlarged view

    Fig. Fuel level sending unit view

  8.  

To install:

  1. Reverse removal procedure for installation.
  2.  

The fuel gauge sending unit (fuel level sensor) is attached to the fuel pump module. The sending unit consists of a float, an arm, and a variable resistor track (card).

The sensor is non-serviceable. If replacement is necessary, the fuel pump module assembly must be replaced.

Refer to fuel pump module removal and installation.

 
label.common.footer.alt.autozoneLogo