Renault Coupes/Sedans/Wagons 1975-1985 Repair Guide

Center Arm

Print

REMOVAL & INSTALLATION





Click image to see an enlarged view

Fig. Fig. 1 Center arm attaching points-rear attaching bolt (2), bushing bolt (3), rubber bushing (4), front attaching bolt (5) and brake limiter rod (6)

All Except LeCar, Alliance and Encore
  1. Place the vehicle on a lift and disconnect the brake limiter control rod.
  2.  
  3. Remove the nuts from the front and rear attaching bolts.
  4.  
  5. Remove the clamp and the center arm retaining bolts.
  6.  
  7. Remove the center arm. The bushings must be pressed in and out of the arm.
  8.  

Installation is in the reverse of the removal procedure. Tighten the bolts as required and check the adjustment of the limiter valve. Tighten the rubber bushing bolt to 30 ft. lb.; the clamp nuts to 10 ft. lb.; the left and right bolts to 60 ft. lb.

 
label.common.footer.alt.autozoneLogo