Rendezvous 2006-2007

Clockspring (Coil)

Print

Centering



  1. Verify the following conditions before centering the Supplemental Inflatable Restraint (SIR) steering wheel module coil:

    The wheels on the vehicle are straight ahead.
     
    The block tooth and the centering mark of the steering shaft is in the 12 o'clock position.
     

  2.  
  3. If available, remove the yellow retaining tab from the SIR steering wheel module coil and save the tab for reassembly.
  4.  
  5. Hold the SIR steering wheel module coil face up by the casing.
  6.  
  7. Slowly turn the SIR steering wheel module coil hub (3) clockwise until the coil ribbon stops.
  8.  
  9. Slowly rotate the SIR steering wheel module coil hub (3) counterclockwise 2.5 revolutions until the this is the CENTER position.
  10.  
  11. If available, install the yellow retaining tab from the SIR steering wheel module coil.
  12.  
  13. If the retaining tab is not available, the use of tape to secure the SIR steering wheel module coil is recommended for installation to the steering column.
  14.  
  15. While maintaining the coil hub in center position, align the centered coil with the horn tower and slide onto the steering shaft.

    Click image to see an enlarged view

    Fig. Steering wheel clock spring module

  16.  

 
label.common.footer.alt.autozoneLogo